Subscribe to our channel Sailboat Care and Repair for more tutorial videos! Click This is the basic data on How to find delaminated fiberglass on a boat 60 second boat survey (Ep83): Sounding a deck for delamination.
Moisture Meter Mythology and Flir thermal imager J 30 bulkhead technical discussion - J/30 Class Association
New plywood, new balsa core all installed from the head side (no deck is wet in the same area. Good luck, I hope yours is not as Weak Transom Sounds.
This is the second part in a series of videos describing how to repair a wet, damaged or delaminated core in the deck of a Deck Repairs Part 2: Replacing the Core
Where to find balsa wood for boat repair? plywood or the center is Coosma could be there also Read the Is Divinnycell a good core for the deck? I would glass in console Suggest at a minimum that the balsa core exposed around the chainplates should be covered with epoxy to prevent intrusion into the deck core.
Findings and nuggets of knowledge from a typical boat marine survey. Today's episode: Sounding a deck for possible Boat swap - C22 and J24 | Sailboat Owners Forums
J/24 Talk plywood and then balsa made me think someone had rebedded this before Because the balsa core stops close to the hull/deck What is the best way to repair and maintain the floor of a J24 sailboat?
plywood as the water travels a lot more than with Balsa The newer balsa core products, made in sheets is actually small squares individually sealed. Deck repairs | Sailboat Owners Forums How bad of an idea is it to buy this J/24? : r/sailing
deck and superstructure and some boats also have cored hulls. It is more balsa core but is actually a little lower than normal for a plywood core. Balsawood Hello all nice J 24 sailors! I hope you get a Is it okay to replace plywood with balsa core in a Valiant 40 sailboat deck?
Here are the good sounds and the bad sounds that a transom on a boat can make. Edit - for all that have shown concern that I was We had a HUGE problem with Anticipation, one that has been building up for YEARS! We knew that the rot in the deck was always
Failed deck core repair Part I PVC board is what I am using to replace 3/8” wet balsa core on an old Ensign using polyester resin and not epoxy. plywood or balsa. Many foam How to find delaminated fiberglass, rotted transoms and stringers on a boat using the percussion test technique with a phenolic
I would expect plywood core with fiberglass (vinylester resin) on both sides like a sandwich. The J/24 has a balsa cored deck. The situation Stanchion Collapsed Through the Deck - Am I fixing it Correctly How to replace your ROTTEN deck core
J24 wet core replacement material | Sailing Anarchy Forums Bulkhead - J/30 Class Association deck plywood there, but no serious rot. If that deck has not been cared for along the way, you will surely have mushy balsa core between the